| a.
|
Demerit mark of defects' length.
|
|
|
(¥°) Under width x length 1"'s defect : Demerit
mark 1 point (1 point)
|
|
|
( ¥± ) Width x length 1.5"'s defect : Demerit
mark 2 point (3 point)
|
|
|
( ¥² ) Width x length 5" half width's defect
: Demerit mark 3 point (5 point)
|
|
|
( ¥³ ) Width x length over half width's defect
: Demerit mark 4 point (10 point)
|
|
|
|
| b. |
Material hole's defects is 4 point
of demerit mark without the size.(10 point) |
|
|
|
| c. |
Flexion must be within 3% of whole
width. |
|
|
(44"'s case, it allowed within 1.3")
|
|
|
|
| d. |
To make a standard 50yds, demerit
mark must be within 13 point in every 1 ROLL. |
spinning